Close

Site Information

Get Started with CuteDigi Plug and Play P2P 16 Channels Relay Kit

Posted on

CuteDigi has a 16-channel plug and play P2P WiFi relay kit. In this post, we show how to set it up.

Before we use it, we need to install the WiFi antenna as below:

Screen Shot 2016-03-05 at 11.11.18 PM

Plug in the power supply and move the switch to ON position. The WiFi plug and play relay will boot into an access point starting with ‘HI-LINK_XXXX’. ‘XXXX’ is different for each items. Connect your PC or smartphone to this access point with a password of ‘12345678’.

IMG_5326

First, we need to find out the P2P setting by enter http://192.168.16.254/p2p.asp in the

bowser. The username is ‘admin’ and password is ‘admin’:

IMG_5334

Modify the password and write down the UUID and the new password. We will need them when we control the relay.

The next step is to configure the Wifi plug and play to connect to your home router.

Enter http://192.168.16.254/ser2net.asp in your browser.

IMG_5325

When it prompts, the username is ‘admin’, and password is also ‘admin’.

IMG_5327

Now we need to change the netmode to ‘WiFi(ClIENT)-SERIAL’:

IMG_5329

and then scan for the SSIDs:

IMG_5330

Click ‘SCAN’:

IMG_5331

IMG_5332

IMG_5333

After we hit the apply button, the wifi plug and play relay will reboot, and the self hosted access point ‘HI-LINK_XXXX’ will disappear, and the wifi relay will connect to your home router.

Install the windows APP, withe UUID and password, we can control the relay wherever we are!Screen Shot 2016-03-05 at 11.49.04 PM

Side note:

After configuration, if we want to change the router that the wifi router connects, we follow the steps below:

  1. Power on wifi relay.
  2. Wait for longer than 35 seconds, press and hold the ‘WPS’ button for 6 seconds or longer.
  3. Power cycle wifi relay, and it should boot into the self hosted AP mode.

The android app can be downloaded at:

comments powered by Disqus